Logo_Mikroshop
Zubehoer  ⊃   Modul  ⊃  LAN  ⊃  ESP32-C3 ETH01 EVO
Zubehoer
2 Bilder
CHF 16.50Preiseinheit per Stk
Artikel ID
2790
Lagerbestand
1 Stk.
Grösse
60x25mm
BeschreibungDieses ETH01 EVO Ethernet Modul basiert auf der Espressif ESP32-C3-S5 MCU in Kombination mit DM9051 Fast Ethernet SPI Controller.

Der DM9051 ist ein Single-Chip-Fast-Ethernet-Controller mit 16 KB SRAM und unterstützt 10/100 M PHY und MAC.

Der ESP32-C3 verfügt im Auslieferungszustand über eine AT Firmware, die Befehle sind ersichtlich im PDF.

Bereits einiges an Info
AT Befehlsliste


5V Power Supply
Fast Ethernet controller with SPI, a 10/100M PHY and MAC, and 16K-byte SRAM
Supports 10BASE-T, 100BASE-TX and 100M
integrated RJ45 Ethernet Connector
Supports
IPv4/TCP/UDP checksum generation and checking
UTP3, 4, 5 in 10Base-T and UTP5 in 100Base-TX with HP Auto-MDIX
compliant with the IEEE 802.3u Specifications
CPU / MPU:
Frequency: up to 160 MHz. RISC-V 32-bit single core microprocessor
384 KByte ROM
400 KByte SRAM
4MB Flash
8 KByte SRAM
802.11 b/g/n/e/i protocol
supports up to 4 virtual Wi-Fi ports
soft-AP Integrated TCP/IP protocol stack
802.11 n (2.4 GHz), up to 150 Mbps
802.11 e: QoS for wireless multimedia technology
Block ACK
802.11 i security features: pre-authentication and TSN
Wi-Fi Protected Access (WPA)/WPA2/WPA2-Enterprise/Wi-Fi Protected Setup (WPS)

Bitte beachten, üblicherweise wird oftmals GPIO0 auf LOW gesetzt um einen ESP8266 sowie ESP32 zu flashen, beim ESP32-C3 wird der Flash Modus durch GPIO09 auf GND aktiviert.
 
PAYPAL LOGO TWINT LOGO Webmoney LOGO Wiederverwendung LOGO
Impressum | Kontakt